Wednesday, March 15, 2023

Give those letters a lift with Foam Adhesive Sheets

During What's Up Wednesday, I shared two ways to add a great lift to your die cuts - especially letters. These are the Alphabet a la Mode dies with the full alphabet - and some duplicate letters to make the job easier - and numbers plus a few other tidbits in the set.

There are two ways shown on how to add height to your die cut letters. First, using the Adhesive Foam Sheets. These are a 4" x 4 1/2" full panel "dimensional" that you add to cardstock/paper before die cutting. Our dies cut right through the paper (even foil!) and the foam sheet. Here's how that card turned out:

Isn't that amazing? The letter just pop right off the page. Now if you don't have your hot little hands on those yet, you can go the old fashioned route of using Adhesive Sheets and die cut 4 sets of each letter. Layer them one on top of the other. If you don't have Adhesive Sheets you can use liquid glue but once you've introduced Adhesive Sheets to your crafting, I'll bet you won't look back.

Here how that card turned out:

I hope you'll give these options a try. To order, see page 127 of the 2022-2023 Annual Catalogue for both products: Foam Adhesive Sheets #152815 for $11 and Adhesive Sheets #152334 for $15.